If the receipt confirmation for the Print, Add and Total commands is to be displayed on the scale
electronics, the following command must be sent to the USB box: X<etx>
Reception is indicated at scale by flashing digits.
The USB protocol requires a matching scale and channel number between the USB-Box and the scale.
You can only receive data from a scale if the number is identical with the retrieval commands of the
USB-Box.
To change the scale & channel number, proceed as followed:
With the crane scale switched on, press the Power On and TEST
buttons simultaneously to open the SETUP menu.
EEEEE appears on the display
Then press the TEST key repeatedly until P13 appears in the
display.
Parameter P13 is used to set the radio frequency channel (Cxx).
Press TARE-key to activate the parameter.
Then select a desired value with the TEST key, this corresponds
to the channel number.
Confirm and close the parameter by pressing the ZERO key.
The display alternately shows P13 and xx, where xx corresponds
to the newly set channel number.
Press the TEST key repeatedly until P14 appears in the display.
Parameter P14 is used to set the scale number.
