Via C.Colombo, 22/A - 42046 - Reggiolo - Reggio Emilia - Italy
Tel. +39 - 0522-211811 - Fax +39 - 0522-97 31 39
www.ehleva.com
By
Mobirolo S.p.A.
- 27 -
VECTOR 70 - 83 - 76
- VECTOR 70 - VECTOR 83- VECTOR 76-
advanced mobular stair system
Fig. 14
Fig. 15
P
L20
B205
Regolare il modulo in funzione della misura della
pedata
“P”
.
Serrare a fondo la vite
K127
precedentemente
lasciata lenta, prestando particolare attenzione alla
posizione del pacco distanziali, il quale deve
mantenere l’allineamento con il supporto.
Si consiglia di utilizzare una guida rigida di
riferimento da applicare ai lati del tubo con un
morsetto durante tale operazione. Fig 14
Montare il gradino
L20
sul supporto
K101
, usando
le viti
B205
, come illustrato in fig. 15.
Assemble the
L20 step
on the
K101
support by
means of the
B205
screws as shown in fig. 15.
Adjust the module according to the
“P” tread
size
.
Fully tighten the
K127
screw whichwas previously
left lose, paying particular attention to the position
of the spacer package, which needs to remain
aligned with the support.
The use of a rigidreference guide is recommended
to be applied to the sides of the pipe with clamps during the operation. Fig. 14
Il faut maintenant régler le module en fonction de la mesure du giron
“P”
.
Serrer à fond la vis
K127
qui a été maintenue desserrée en précédence, en prêtant une attention particulière à la
position du groupe des bagues intermédiaires qui doit maintenir le bon alignement au support.
Pendant cette opération, nous conseillons d’utiliser un guide rigide de repère à appliquer aux côtés du tube avec une
broche de serrage. Fig. 14
Monter la marche
L20
sur le support
K101
en
utilisant les vis
B205
, comme illustré Fig. 15.
Nun ist das Modul in Funktion des Auftrittsmaßes
“P”
einzuregulieren.
Die zuvor locker gelassene Schraube
K127
ganz festschrauben und dabei besonders auf die Position des
Distanzstückepakets achten, das die Ausrichtung mit dem Träger bewahren muss.
Es wird empfohlen, eine steife Bezugsführung zu verwenden und sie bei diesem Vorgang mit einer Klemme an den
Seiten des Rohres anzubringen. Abb. 14
Die Stufe
L20
mit den Schrauben
B205
auf den
Träger
K101
montieren, siehe Abb. 15.
Regular el módulo en función de la medida de la contrahuella
“P”
.
Atornille a fondo el tornillo
K127
previamente dejada floja, prestando especial atención a la posición del paquete de
espaciadores, que debe mantener la alineación con el soporte.
Se recomienda utilizar una guía de referencia rígida para aplicar a los lados del tubo con una abrazadera durante
esta operación. Fig.14
Monte el peldaño
L20
sobre elsoporte
K101
,usando
los tornillos
B205
, como se ilustra en la fig. 15.