Replace the Blade Assembly
24
Check at this step to make sure the previous assembly steps are correct:
Use a vernier caliper to measure the depth of the shaft end which is lower than the outer
washer surface. It should be less than 0.6mm. If the depth exceeds 0.6mm, reassemble the
blade set step by step following the previous steps.
The shaft end should be a
little lower than the outer
washer surface (<0.6mm)
Summary of Contents for HT2400E
