Ego Power+ ST1610E-T, Manual

Page: 8 / 272

56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1610E-T
8
EN
SPECIFICATIONS
Voltage
56 V
No-Load Speed
Low speed range:
3500-4800 min
-1
High speed range:
4000-5500 min
-1
Cutting Line Mechanism LINE-IQ FEEDING
Cutting Line Type 2.4 mm nylon twist line
Cutting Width 40 cm
Recommended Operating
Temperature
0°C - 40°C
Storage Temperature -20°C - 70°C
Weight (without battery pack) 3.5 kg
Measured sound power level
L
WA
90 dB(A)
K=2 dB(A)
Sound pressure level at
operator’s ear L
PA
77 dB(A)
K=3 dB(A)
Guaranteed sound power level
L
WA
(measured according to
2000/14/EC)
92 dB(A)
Valuation of
vibration a
h
Front
handle 3,89 m/s 2
K=1.5 m/s
2
Rear handle
2,7 m/s 2
K=1.5 m/s
2
◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which
the tool is used; In order to protect the operator, user
should wear gloves and ear protectors in the actual
conditions of use.
DESCRIPTION
KNOW YOUR LINE TRIMMER (Fig. A1)
1. Variable Speed Trigger
2. Rear Handle
3. Locking Tongue
4. 2-Speed Switch
5. Speed Indicator
6. Height Locking Collar
7. Quick Adjustable Front Handle
8. Quick-release Lever
9. Hinge & Locking Bolt
10. POWERLOAD
TM Button
11. Trimmer Head (with LINE-IQ Feeding)
12. Cutting Line
13. Release Tab
14. Line-Cutting Blade
15. Guard
16. Ejection Mechanism
17. Latch
18. Battery Release Button
19. Hex Wrench
20. Shoulder Strap Loop
21. Shoulder Strap
PACKING LIST (FIG. A1)
ASSEMBLY
UNFOLDING THE SHAFT
WARNING: In order to avoid pinching your hands
or fingers, do not hold the shaft at the joint.
WARNING: Do not attempt to start the trimmer
until the shaft has been locked.
Unfold the shaft gently, ensuring the cable inside the
shaft and lock it with the bolt by the supplied wrench
(Fig. B1 & B2).
MOUNTING THE GUARD
WARNING:
Always wear gloves when mounting
or replacing the guard. Be careful of the blade on the
guard and protect your hands from being injured by
the blade.
Position your trimmer so that the trimmer head faces
up (Fig. C1). Align the guard mounting holes with the
assembly holes and then lock the guard on the shaft
base with the two screws (Fig. C2).
NOTICE:
Make sure the guard is fixed according to Fig.
C1 & C2, any reverse fixing will cause great danger!