Ego Power+ ST1610E-T, Manual

Page: 14 / 272

56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1610E-T
14
EN
PROBLEM CAUSE SOLUTION
Trimmer head con-
tinues to release line
automatically.
◾
Light cutting line is used.
◾
Use recommended nylon cutting line with
diameter 2.4 mm.
Grass is wrapped
around trimmer head
and motor housing.
◾
Cutting tall grass at ground level
◾
Cut tall grass from the top down, removing
no more than 20 cm in each pass to prevent
wrapping.
The blade is not cutting
the line.
◾
The line-cutting blade on the
edge of the guard has become
dull.
◾
Follow instructions to sharpen the line-cutting
blade with a file or replace it with a new blade.
Cracks on the trimmer
head
◾
The trimmer head is worn out.
◾
Replace the trimmer head immediately
following “
TRIMMER HEAD REPLACEMENT
” in
this manual.
The cutting line cannot
be wound into the trim-
mer head properly.
◾
Improper cutting line is used.
◾
We suggest that you use EGO original nylon
cutting line. If using EGO nylon line and the
problem persists, please call EGO customer
service for advice.
◾
Grass debris or dirt has
accumulated in the trimmer
head and blocked the movement
of line spool.
◾
Remove the battery, open the trimmer head and
clean it thoroughly.
◾
Motor is overheated due to
repeatedly operating the line
winding system.
◾
Let the line trimmer work under no load for
a few minutes to cool the motor, then try to
reload the line.
◾
Low battery capacity
◾
Charge the battery
◾
The line is not wound into the
spool assembly.
◾
Pull out the line and reinsert it.
◾
Trimmer head is defective.
◾
Call EGO Customer Service for help.
The cutting line cannot
be passed through the
trimmer head when
inserting the line.
◾
The cutting line is split or bent
at the end.
◾
Cut the worn end of line and reinsert.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.