56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1400E-ST
7
EN
SPECIFICATIONS
Voltage
56 V
No-load Speed
Low speed set:
3000-4500 RPM
High speed set:
4000-5800RPM
Cutting Mechanism
Bump Head
Cutting Line Type
2.4mmnylon
twist line
Cutting Width
35 cm
Recommended Operating
Temperature
0°C-40°C
Recommended Storage Temperature -20°C-70°C
Optimum Charging Temperature
5°C-40°C
Weight (without battery pack)
5.8 kg
Measured sound power level L
WA
88.98 dB(A)
K=2
dB(A)
Sound pressure level at operator’s
ear L
PA
68.96
dB(A)
K=2 dB(A)
Guaranteed sound power level L
WA
(measured according to 2000/14/EC)
91 dB(A)
Valuation of
vibration a
h:
Front-assist
handle
3.2 m/s
2
K=1.5 m/s
2
Rear handle
2.3
m/s
2
K=1.5 m/s
2
◾
The declared vibration total value has been measured
nin accordance with a standard test method and may
be used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used; In order to protect the operator, user should wear
gloves and ear protectors in the actual conditions of use.
DESCRIPTION
KNOW YOUR LINE TRIMMER (Fig. A1)
1. Rear Handle
2. High/Low Speed Switch
3. Adjustable Front-Assist Handle
4. Hinge
5. Line-Loading Button
6. Guard
7. Lock Pole
8. Height Locking Collar
9. Switch Trigger
10. Locking Tongue
11. Trimmer Head (Bump Head)
12. Line Cutting Blade
13. Release Tab
14. Cutting Line
15. Battery Release Button
16. Latch
17. Electric Contacts
18. Ejection Mechanism
19. Hex Wrench
PACKING LIST
(
FIG.A1
)
ASSEMBLY
UNFOLDING THE SHAFT
WARNING:
Do not hold the shaft at the joints in
order to avoid pinching your hands or fingers.
WARNING:
Do not attempt to start the trimmer until
the shaft has been locked.
Unfold the shaft gently, ensuring the cable inside the shaft,
and lock it with two screws by the supplied wrench (Fig. B1
& B2).
MOUNTING THE GUARD
Position your trimmer so that the trimmer head faces
up (Fig. C1).Align the guard mounting holes with the
assembly holes and then lock the guard onto the shaft
base with the two screws (Fig. C2).
NOTICE:
Make sure the guard is fixed according to
Fig. C1 & C2, any reverse fixing will cause great danger!
MOUNTING AND ADJUSTING THE FRONT-ASSIST
HANDLE
1. Loosen the locking pole in the front-assist handle
and remove the locking pole and wing nut form the
front-assist handle (Fig. D).
D-1 Front-assist handle D-3 Wing nut
D-2 Clamping block
D-4 Locking pole
2. Push the front assist-handle onto the shaft between
the Height Locking Collar and hinge (Fig. E).
3. Insert the clamping block into the handle slot (Fig. F).
4. Mount the locking pole lever and pre-tighten the wing nut.
Make sure that the front-assist handle is positioned upwards
and points toward the top of the rear handle (Fig. J).
