EGi 10401 COMPACT, Instruction Manual

Page: 24 / 38

25
S w i t c h i n g o n t h e s y s t e m
VERY IMPORTANT:
Before connecting the equipment to the power supply or mains, check that the correct
voltage has been selected using the selector on the bottom of the console.
230 V~
(default voltage)
, 115 V~ (depending on country).
SWITCHING ON
• To start up the system, press the top left key so that the console goes from OFF stand-by
to ON .
LANGUAGE
• Select the language using the and keys.
Press
OK
to confirm and the key to exit.
• After selecting the language the system requests the SET-UP or selection of the zones that are going
to be used.
ZONE 1 ZONE 3
1 1
ZONE 2 ZONE 1+2
1 0
SELECT
ACTIVE ZONES
• In the example shown above,
ZONE 3
is added to
ZONE 1
and
ZONE 2,
that are the default zones.
The system also allows
Z1
and
Z2
to be combined into one single zone so that the 2 rear outputs
Z1
and
Z2
operate at the same time, making a total of 100 W available for one zone provided that
each output has a different line of speakers. In this case, music and messages will be played at
the same volume through both outputs.
So:
If
ZONE 1
or
ZONE 2
is activated,
ZONE 1+2
will be automatically disabled.
If
ZONE 1+2
is activated
ZONE 1
and
ZONE 2
are automatically disabled.
As a rule, if you are not sure
we recommend activating the 3 zones individually.
• Once the zones have been selected, press the
OK
key to proceed with SET-UP, or press the key
to return to the home screen.
AUTOSCAN
• After the zone SET-UP has been completed, the
AUTOSCAN
process commences.
This process memorises the 30 best radio stations according to the reception sensitivity and scans
for their names by FM/RDS. This process can take more than one minute.
• Once completed, the system is now initially programmed for use and the start screen is displayed.
• On the start screen the system is ON.
To switch it off, press the top left key. The console will go to stand-by mode. The console will not
lose the data (even in the event of a power cut) and will go to OFF stand-by.
A U T O S C A N
N E W
F M L I S T
2 7 / 3 0
K I S S F M
ZONE 1
FM
ZONE 2
FM
ZONE 3
FM
ZONE 1 ZONE 3
1 0
ZONE 2 ZONE 1+2
1 0
SELECT
ACTIVE ZONES
First connection
When first connected to the power supply, the system carries out an initialising
process that begins when it begins to receive power.
• The
EGi
logo is displayed and the unit goes to stand-by.
• After a few seconds the screen turns off and can be activated again
when any key is pressed.
L A N G U A G E
D E U T S C H
E N G L I S H
E S PA Ñ O L
F R A N Ç A I S
I TA L I A N O
P O RT U G U E S
SELECTION OF ZONES AND SET-UP
• Only select the zones that are going to be used or that are connected.
For example, if only
ZONA1
is required then select
1
only.
If only 2 or 3 is required, select the desired zone only.
If more than 2 or 3 zones are required, select the zones to be used, leaving the unwanted zone free.
(Console start screen)
YES
/ NO
YES
/ NO
YES /
NO
YES /
NO
en