Now, turn the board over so the WiFi module is on the bottom, and using the remaining
resistors/leads stick wires through the remaining 12 WiFi module pads, soldering them and
clipping them as you go. When you are done, all 16 pads (8 on each side) should be soldered
on the bottom of the board, and all 16 pads on the WiFi module should be soldered.
Note: Your WiFi module may have six extra pads opposite the antenna, do not solder these or
do anything at all with them.
__
Mount the .1uF capacitor
Locate the spot for the .1 uF capacitor, just below the WiFi module. This is the capacitor that
comes in the PAPER tape carrier. Solder in place, making sure that you do not get solder on
any pads on the WiFi module (especially the aforementioned 6 pads at the end, if they are
present).
__
Mount the 1K resistor
Locate the 1K resistor (marked “102”) near the left side of the board. Solder in place.
