Instructions
1.
The motion detector can be mounted using the double-sided tape or by using the screws.
2.
For mounting with screws:
a.
Remove the screw at the bottom of the motion detector and remove the front cover.
b.
Use the pre-punched holes in the motion detector as a template to mark the drill
holes on the wall.
c.
Drill the holes and use the plugs for stone or plaster walls.
d.
Secure the back of the motion detector to the wall using the screws.
e.
Replace the front cover and secure with the screw at the bottom.
STEP 4: CHECK AND TEST
To make sure that the motion detector functions correctly it is advisable to test the motion detector.
Turn the alarm system on by using your remote control (press red button) and move into the motion
detector's field of view. If the alarm is triggered the motion detector has been installed correctly.
Please note! The motion detector incorporates a battery saving function of 1 minute. This
means that the detector will only be active after it has not detected any motion for a period of
1 minute. When testing the motion detector ensure that the room has been empty for at least
1 minute before running the test.
Congratulations! The installation is complete.
MAINTENANCE
Battery
The motion detector is powered by one 1,5V AA (LR6) Alkaline battery. Depending on use, the
average life of the battery is 3-5 years. The motion detector itself will indicate when the battery is
low. When the battery has power left for about one month you will receive the following warnings:
1.
The motion detector's status indicator will start to flash.
2.
In your Egardia account you will see the message "Battery low level" under the tab "Alarm
history".
3.
You will receive a one-time message by telephone, SMS or email.
4.
The central indicator light (Alarm) of your gateway is lit yellow. After the battery has been
replaced the gateway will return to normal status.
Replacing the battery
1.
Ensure that the alarm is turned off.
2.
Remove the screw at the bottom of the motion detector and remove the front cover.
3.
Remove the old battery and replace by a new 1,5V AA (LR6) Alkaline battery. Ensure that the
battery polarization is correct.
4.
Replace the front cover and secure with the screw at the bottom.
Testing the motion detector
Press the "Reset" button at the side of the gateway for at least 5 seconds. The top indicator light
(Status) of the gateway flashes green. The gateway is ready to test a registered motion detector.
The motion detector functions correctly when the gateway beeps twice as soon as a registered
motion detector senses a motion or after you press the register button of the motion detector.
When you are finished testing press again the "Reset" button of the gateway for at least 5
seconds. The gateway returns to normal operation.
3
Summary of Contents for MOV-31
Page 1: ......