3
Functions other DIP switches
DIP switch number 2: configure whether the LED indicators of the bell box will keep glowing
after an alarm. When the alarm system is turned off the bell box will sound 2 beeps to confirm
an alarm has been triggered.
DIP switch 2
Alarm system
Duration active LED indicators
ON
ON
Until the alarm system is turned off
ON
OFF
Depends on settings of DIP switch 3
and 4
OFF
ON/OFF
Depends on settings of DIP switch 3
and 4
DIP switch number 3 and 4: configure the duration that the bell box emits audible and light
signals during an alarm. The default duration is 3 minutes.
DIP switch 3
DIP switch 4
Duration sound and light signals
ON
OFF
5 minutes
OFF
ON
10 minutes
OFF
OFF
3 minutes
ON
ON
1 second (test)
DIP switch number 5: configure whether the siren has to be activated or deactivated. The siren
is activated by default.
DIP switch number 6: to erase the memory of the bell box. To erase the memory, switch the
battery switch to "OFF". Now wait for 5 minutes and set DIP switch number 6 to "ON". Switch
the battery switch back to "ON". The LED indicators will flash in sequence (from left to right
and back) and a beep sounds to confirm. Set DIP switch number 6 back to "OFF".
DIP switch number 7: configure whether the control function has to be activated or deactivated.
The control function is activated by default so that the bell box regularly transmits a control
signal to the Egardia gateway.
STEP 3: MOUNT BELL BOX
Place the bell box in a highly visible location on the exterior wall. Before mounting use the key fob to
test the desired mounting place is within range of the gateway.
Important guidelines
The optimal location for the bell box is highly visible but also high enough to be out of reach of
a burglar.
The end of the tamper switch protrudes out of the backside of the bell box so that an alarm is
triggered when the bell box is pulled from the wall. Ensure during mounting whether the tamper
switch is fully pressed against the wall.
Instructions
1.
Ensure that the battery switch is set to "OFF" so the bell box can be mounted without triggering
a tamper alarm.
2.
Use the 4 pre-punched holes in the bell box to mark the drill holes on the wall.
3.
Drill the holes and use the plugs for stone or plaster walls.
4.
Secure the back of the bell box to the wall using the screws.
5.
Ensure DIP switch number 1 is set on "OFF" and that the other DIP switches are set as
desired.
6.
Switch the battery switch to "ON" to activate the tamper switch.
7.
Replace the cover and secure with the security screw at the bottom.