18
DISPOSAL
Dispose worn out/defective machine tools according the local/national regulations. Fully
disassemble machine for the necessary disposal. Separate materials according to local environmental
specifications. Dispose environmentally hazardous greasing, cooling or cleaning agents in order to
avoid environmental contamination.
ENVIRONMENTAL REGULATIONS
When working on or with the equipment, it is imperative to observe all legal requirements in
regards to waste-disposal and proper recycling.
In particular during installation, repair and maintenance work, water damaging
agents, such as:
• lubricating grease and oil,
• hydraulic fluid,
• coolant,
• solvent containing cleaning agents
must not leak into the ground or reach the sewage system.
These materials must be stored, transported, contained and disposed of in suitable containers!
TROUBLESHOOTING
Problem
Cause
Remedy
Machine doesn’t start
Not connected to compressed
air
Rotor rusty due to humidity
Vanes jam (worn out)
Gear blocks
Connect and open the supply
line
Disassemble motor and
clean Check functioning of
maintenance unit
Disassemble motor and clean,
replace worn out parts
Disassemble gear, clean,
replace worn out parts
Valve trigger jams
Impurities in the valve
Clean valve seat
Machine is rotating too slowly
Operating pressure is too low
Rotor is rubbing against the
end plate / cylinder bushing
Gear parts are worn down
Increase the operating pressure
on the machine to 6 bar
Dismantle and clean the motor;
replace worn parts and align
the motor again
Dismantle and clean the
gearing; replace worn or
damaged parts
