46
Analogue Bar Graph
The bar graph provides an analogue indication of the measured input. For most measurement
functions, the bar graph updates 10 times per second.
Using MAX MIN
The MAX MIN mode stores minimum (MIN) and maximum (MAX) input values. When the input
goes below the stored minimum value or above the stored maximum value, the Meter beeps and
stores the new value.
Press MAX MIN to enter MAX MIN mode. The sampling time is every 2 seconds. The maximum
reading and MAX are shown on the left secondary display. The minimum reading and MIN are
shown on the right secondary display. The primary display shows the current measurement reading.
Press MAX MIN the second time, the current measurement reading is shown on the left
secondary display. The minimum reading and MIN are shown on the right secondary display. The
primary display shows the maximum value.
Press MAX MIN the third time, the current measurement reading is shown on the left secondary
display. The maximum reading and MAX are shown on the right secondary display. The primary
display shows the minimum value.
Each subsequent press of MAX MIN steps through the above three modes.
To exit MAX MIN mode, press EXIT.
Press HOLD to stop the Meter updating reading.
MAX MIN mode can only be used under MANUAL ranging mode.
3. MAKING MEASUREMENT
Introduction
Chapter 3 explains how to make measurements. Most measurement functions can be selected by
using the rotary switch.
While letters or symbols identify primary functions; blue letters or symbols identify alternative
functions. Press the
BLUE
button to access these alternate functions.
A. Measuring Voltages
Warning!
To avoid harms to you or damages to the Meter from electric shock, please do not
attempt to measure voltages higher than 1000V, although readings may
be obtained.
Figure 3-1. Voltages Measurement
