1. Before arriving at your flying field, be sure all your batteries are properly charged and all radio
systems are in proper working order.
2. Install the wings onto the fuselage being careful to align the wing tube with the wings and not force it.
The wing tube may be initially tight but will loosen some with use. Guide your servo wires into the
fuselage openings and connect to the proper aileron channels. Servo clips are recommended. Once you
have the wings fully seated in the fuselage tighten the wing bolts inside the fuselage.
3. Fill your fuel tank making sure your vent line is not plugged or capped. With the canopy off, this is a
good time to check for any fuel leaks.
4. Position the canopy in place and tighten the canopy screws. Be sure to use the supplied rubber
washers under the screw heads.
5. If you have removed your horizontal stabilizers, install them once again and check all bolts and
connections.
6. Check all control surfaces for secure hinges by performed a slight tug on the control surfaces and
observing if there is any give in the hinges. Check all control rods, ball links, servo screws, etc. for
proper operation and installation.
7. Check your batteries and perform a proper range check once again with the engine off and running. Be
sure all surfaces are moving in the correct direction and the proper amount for your flying setup.
8. You are now ready for your maiden flight! Good luck and enjoy your new aircraft! If you have any
comments or questions about this manual or the aircraft please email.
RedAero RC
18502 Crosswind Ave
N. Ft. Myers, FL 33917
239-560-8175
