EFM Synthesizers EFM Mad Mouse Pro, Assembly And Setup Manual, Page: 17 / 27

Final Assembly and Setup
Now is a good time to install and line up the spacers you intend to use to suspend the board over the controls. The best way I've
come up with is to attach the spacers to the board. Put a drop of model paint or ink on the end and then position it in place. The paint
will mark the inside of the case so you can drill the holes in the right place.
There are two test traces on the board break the trace between the large PAD-A and the two small pads connected to PAD-B. This
allows the power switch to turn the unit off.
Break the trace between PAD-A2 and PAD-S. This allows the Sync switch to disconnect VCO2 from pitch-bend CV for Sync
sweeps.
Secure the board in the case .
Glide 0%
Tune 50%
Waveform Saw
Sync Off
VCO2 offset 50%
VCO mix 50%
Volume 25%
P. Bend Destination VCO
Mod Destination VCO
Mod Wave Tri
Mod Rate 80%
Mod Wave Shape 50%
VCA - Attack 0%
VCA- Decay 100%
VCF - Cutoff 100%
VCF- Resonance 0%
VCF- Envelope 0%
VCF-Attack 0%
Set the controls to the basic patch
VCF-Decay 100%
Install all of the ICs. U1 the +12V regulator needs to be in thermal contact with the case or a small heat sink can be used.
Connect the output to a monitor amp and connect the power transformer. Turn the unit on.