EFKA
DA320G5351
5
1 Putting into Service
Before putting the control into service, the following must be ensured, checked and/or adjusted:
The correct installation of the drive, position transmitter and accompanying devices, if necessary
If necessary, the correct adjustment of the direction of motor rotation using parameter 161
The correct positioning speed using parameter 110
The correct maximum speed compatible with the sewing machine using parameter 111
The setting of the positions
The setting of the remaining relevant parameters
Start sewing in order to save the set values
See instruction manual for details!
2 Setting and Putting into Service with the Aid of the Fast Installation
Routine (SIR)
The Fast Installation Routine (SIR) passes through all parameters
necessary for programming the functional sequence and the positions.
Input parameter 500
Parameter for direction of motor rotation
Parameter for transmission ratio
Important!
The transmission ratio should be
determined and indicated as precisely as possible.
Parameter for type of position sensor
Parameter for position 1
Parameter for position 2
The values can be varied by pressing the +/- keys. When the parameter is displayed on the V810 control panel, press
the E key once more for the value to be displayed.
Exit the routine any time by pressing the
P
key once, and select a new parameter. Exit programming by pressing the
P
key
twice, and the drive is ready for a new sewing operation.
See instruction manual for details!
F-272
End SIR
F-451
F-453
F-270
P
E
E
E
E
F-161
F-500
Code 3112
F-200
E
>
E
E
No
Yes
K L25 18
>
