EFI Fiery proServer, Installation Manual, Page: 1 / 6

© 2014 Electronics For Imaging
11 July 2014
Fiery proServer Installation Guide
This document describes how to install the EFI
™
Fiery
®
proServer. It is intended for customers
who are installing the Fiery proServer without the assistance of a qualified technician. This
document covers the following topics:
• Checking the site conditions (see page 1 )
• (Optional) Installing the furniture (see page 2 )
• Connecting the Fiery proServer (see page 2 )
• Network bridging (see page 2 )
• Licensing Fiery XF (see page 4 )
• Setting up Fiery XF (see page 5 )
• Completing the installation (see page 6 )
Checking the site conditions
Before you install the Fiery proServer, check the site conditions.
Printer readiness
• Is the printer configured for use with the Fiery proServer? For the correct settings, see the
documentation that accompanies the printer.
• Is adequate space available near the printer for the Fiery proServer?
• Does the printer require service or adjustments?
Before you install the Fiery proServer, print the printer color test page.
If the quality of the test page indicates that the printer needs adjustment, complete the
necessary service to the printer.
• Make sure that there is sufficient space for the Fiery proServer and optional furniture (if
present).
There should be sufficient space for the cables at the back and sides of the Fiery proServer.
F
IGURE
1:
Space requirements
Back panel
Side panel
20cm+ (8 in.)
Fiery proServer
20cm+ (8 in.)
45129132
*45129132*