Effigy Labs Control Pedal Quick Start Guide v1.3 February-2019
Page
10
of
18
Troubleshooting Guide
•
Pedal outputs “noise” data while idling:
tension is too
tight or too loose. If loose, tighten until noise
disappears. If tight, loosen until noise disappears. If
warbling persists, contact Effigy support.
•
Sensitivity Knob doesn’t work:
check to see if knob is
flipped in position 4 mode. Light phases blue for
controller mode, red for sensitivity mode. To flip knob,
hold down knob for 2-3 seconds and release.
•
Pedal functions behave as in “on-off” mode
: Your
sensitivity may be turned all the way to the right. If you
don’t want this, adjust the sensitivity. If your light
phases blue, switch to sensitivity mode (see above
bullet) to adjust sensitivity with the knob.
•
Mode switch seems to miscount seconds to flip the
knob/switch presets/channels
– Notice the LED flashes
red as soon as you hit the mode switch – at moment
“zero”, then every second. For example, the light will
blink four times to count off three seconds. Think of it
as “zero, one, two, three” if you like, or use the
