8
Wooden doors
Mark the drilling points and then remove the drilling template and the
code lock from the door. Use wood drills of 10 mm dia. for the M 5
fixture screws and of 16 mm dia. for the battery connection cable
(see
page 23 for further details).
Sheet metal and metal doors
Mark the drilling points and then remove the drilling template and the
code lock from the door. Use metal drills of 6 mm dia.
(see page 23 for
further details).
Widen the fixture borings to 10 mm in diameter on the outside of the
door using a centre bit. The boring for the battery connection cable has
to be widened on the inside and outside of the door to a diameter of 16
mm.
In the case of sheet metal doors the M 5 joining screws may not be
overtightened, otherwise the door may be deformed in the area of the
lock.
Finished assembly
Fitting of the code lock
,
s outer furniture
Fitting of the code lock
,
s inner furniture
Screw connection of the code lock furnitures:
Each packing unit includes 4 x 2 hardware screws. The length of the
fixture screws in determined by the door leaf thickness and the code
lock type ordered.
Code lock ordering off
495-107 / -108
495-117 / -118
door leaf thickness
38-50 mm
50-70 mm
Furniture top
2 pcs. M 5 x 55
2 pcs. M 5 x 80
Furniture bottom
2 pcs. M 5 x 45
2 pcs. M 5 x 65
Press-fit and screw connection of door handles
The code lock should be put into operation before the 4 plastic cover
bushes supplied for the installation borings are pressed on
(see initial
operation and programming).
Initial operation and programming
Prior to initial operation of the electronic code lock a 9 volt battery block
has to be inserted into the code lock. For this purpose the battery
compartment on the side of the inner furniture of the code lock has to
be opened using a screwdriver, in order to plug in the battery via the
connection clip. The battery block is not supplied by us.
Summary of Contents for 495-107
Page 22: ...22...
