EFF EFF 309X, Manual, Page: 8 / 28

SETTABLE FUNCTIONS OF 709X (narrow style)
CHANGING THE FOREND Fig. A
1. Set the lock case forend up on the table.
2. Unscrew the fixing screws and remove the forend. Please note that the double action
bolt and its two bushings do not fall off.
3. Set another forend and screw in the screws. Use LOCTITE 243 on each fixing screw.
REMOVING THE MANIPULATION PROTECTION COVER Fig. B
SETTING THE ELECTRICAL FUNCTION: FAIL LOCKED -> FAIL UNLOCKED Fig. C
(Needed tool: 1.5 mm Allen key)
The lock case is delivered in Fail locked mode:
Power off -> Handle does not open the lock.
Power on -> Handle opens the lock.
The lock case can be changed in Fail unlocked mode. Then the lock works electrically in the
following way:
Power off -> Handle opens the lock.
Power on -> Handle does not open the lock.
The electrical function is changed from Fail locked into Fail unlocked mode in the following way:
1. Remove the Allen screw from the right-hand hole ( Fig. C1 ).
2. Screw in the Allen screw in the left-hand hole ( Fig. C2 ). The Allen screw should settle
a little under the plastic edge, but please note not to use strength.
When the Allen screw is fixed in the right-hand hole, the electrical function is Fail locked.
When the Allen screw is fixed in the left-hand hole, the electrical function is Fail unlocked.
SETTING THE EXIT HANDLE SIDE Fig. D (Needed tool: 2.5 mm Allen key)
Exit side of the lock case is set with an Allen screw. The handle, of which side the Allen screw
is fixed, always opens the lock, while the handle of the other side is controlled electrically.
The lock case is delivered so, that the Allen screw is fixed on the caser side of the lock case.
Exit handle side can be changed in the following way:
1. Remove the Allen screw from the caser side of the lock case ( Fig. D1 ).
2. Screw in the Allen screw in the corresponding hole on the other side of the lock case
(
Fig. D2 ).
CHANGING THE HANDING OF THE TRIGGER BOLT Fig. E (Needed tool: 2.5 mm Allen key)
1. Locate the Allen key between the two springs in the back of the lock case in the Allen
screw-head of the trigger bolt (
Fig. E1 ).
2. Loosen the Allen screw, so that the trigger bolt moves forward and can be turned around
(
Fig. E2 ). Please note not to unscrew the Allen screw.
3. When the handing of the trigger bolt is set, tighten the Allen screw ( Fig. E3 ).
When the needed settings have been done, attach the manipulation protection cover.
ATTACHING THE CABLE Fig. F
1. Unscrew the fixing screw and remove the cable clamp.
2. Connect the cable into the connector. Fix the cable clamp.
SETTING 8/9 SNAP SPINDLE ADAPTERS Fig. M
8/9 snap spindle adapters are set if the lock case is installed with 8mm spindle. The adapters
must be set on the both sides of the lock case.
There are two flat sides and two sides with a cup in a adapter. The round markings on the
handle follower of a lock case denote the direction, in which the adapter is set. With 309X
and 409X the direction of the adapter has to be noticed. With 709X the direction
has no significance.
ENGLISH
8