Section
II:
Installation
2.0.INS.SL-518
4.
Install the hydraulic adapters and hoses from the three-section hydraulic control
5.
valve to the hydraulic cylinder (
Pt. No. 21P84
) shown on drawings
Pgs. 6-12 & 6-13
of the manual. Tie up all loose hoses as required. Be sure the hoses are routed to
avoid exhaust components and all moving components of the rear axles.
6.
After the start procedure has been completed on the hoist, verify that the movement
of each control lever corresponds to the movement of the cylinders per the figure
below. Operate the stabilizer through 5 to 8 cycles to remove the air from the
hydraulic cylinders and lines.
2-16
Summary of Contents for SWAPLOADER SL-518
