Efco Swaploader SL-330, Parts And Operation Manual

Page: 70 / 134

11/02/99
FENDER ASSEMBLY, TANDEM AXLE
Steel (11H14)
specific application.)
8. Weld fender tubes to hoist mainframe. If
attaching the fender tubes to the truck
chassis, an additional mount plate may
need to be fabricated so the assembly can
be bolted to the truck chassis.
9. Attach fender bracket weldment [Part No.
10H74] to mounting plate [Part No. 21H37]
using fasteners provided (See FIG. 3).
INSTALLATION INSTRUCTIONS (continued)
4. Mark mounting holes through the fender bracket weldment onto the fender.
Remove the bracket and drill 7/16” dia. Holes in fender (See FIG. 3).
5. Attach fender bracket weldments to fender using fasteners provided.
6. Weld mounting plates [Part No. 21H37] to fender tubes [Part No. 21H61].
7. Position fender tubes with mount plates on hoist mainframe; align with fender
bracket weldments. (NOTE: Fender tube length may need to be modified to fit
MATERIAL LIST
ITE
M
QTY P/N DESCRIPTION
WT lb.
PER EA.
1 6 10H74 FENDER BRACKET WDMT. 8.05
2 6 21H37 MOUNTING PLATE 1.09
3 6 21H42 RUBBER SPACER .85
4 6 21H61 FENDER TUBE 1.26
5 48 00P34 3/8-16 UNC LOCKING NUT .02
6 72 00771 3/8 DIA. FLAT WASHER .05
7 24 00P78 3/8 DIA. NYLON WASHER -
8 24 00P44 3/8-16 UNC X 1-1/2 HHCS .07
9 16 01P21 3/8-16 UNC X 2-1/2 HHCS .09
10 8 00P99 3/8-16 UNC x 4 HHCS .11
11 2 90P36 FENDER, STEEL TANDEM 77.00
TOTAL 228.86
1
5
2
4
5
3
8
7
9
2 X 4
SPACER
11
5
6
10
6
7
4 @ 6”
CENTERS
7/16 DIA. HOLE
HOIST
MAINFRAME
(REF)
TRUCK
(REF)
6
ADDITIONAL NOTE:
Prior to any welding, consult the truck
manufacturer for any special pre-
cautions that may need to be taken.
Typically the batteries must be dis-
connected and the ground lead from
the welder should be as close to the
part being welded to avoid the
possibility of arcing across bearings,
gears, etc
.
6
6
1800 NE Broadway Avenue, Des Moines, Iowa, U.S.A. 50313-2644
Phone: (515) 266-3042
•
Fax: (515) 313-4426
•
Toll Free: (888) 767-8000
E-Mail: sales@swaploader.net
•
Web Site: www.swaploader.com