P5VPX97-AT
Installation
Installing the CPU
Installing Memory
1. Open the locking arm of the CPU
socket.
2. Align the CPU to the socket then insert
pressing firmly into the socket.
3. Make sure the CPU is seated firmly into
the socket then close the locking arm
of the socket.
Most Pentium Class CPUs require a
cooling fan and heat sink for appropriate
operating temperature requirements.
Please refer to the cooling fan
manufacturer for details on installing the
cooling fan.
CPU Socket 7
Alignment Edge
Alignment Edge
Pentium CPU
(2) Align the CPU
(3) Close Arm
Please make sure to configure your
system board for the correct BUS speed,
CPU frequency, and CPU voltage settings.
Refer to the “Jumper Setting” Section for
details.
SIMMs: Single Inline Memory Modules
DIMMs: Dual Inline Memory Modules
SIMM types supported:
F.P. (Fast Page) DRAM
EDO (Extended Data Out) DRAM
Specs:
5 Volt
72-Pin
70ns or faster
Parity or non parity
When installing SIMMs:
** Must be installed in pairs. Each pair
must be of equal size, speed, and type.
** The identical SIMM types must occupy
SIMM sockets 1&2 and/or 3&4 but not
in any other combinations. SIMM 1&2
and 3&4 make up a memory bank.
Each bank must have the same
memory type.
DIMM types supported:
EDO (Extended Data Out) DRAM
SDRAM (Synchronous) DRAM
Specs:
3.3Volt
168-Pin
Unbuffered
ECC Supported Via Chipset
**May be installed one DIMM at a time.
Maximum memory capacity is 256MB.
Due to the voltage difference, we strongly
recommend not to use SIMMs and DIMMs
at the same time.
(1) Open Arm
SIMM INSTALLATION
1. Locate the alignment notch of the SIMM
2. Insert the SIMMs at a 45 degree angle
3. Snap the SIMMs into place as shown in
the illustration.
Maximum memory capacity of the Viking II
is 256MB
.
DIMM INSTALLATION
1. Open the locking levers on the DIMM
socket.
2. Align the DIMM to the socket.
3. Press firmly down on the DIMM
Maximum memory capacity of the Viking II
is 256MB
.
(1) Open locking
arms
(2) Align the DIMM to
the socket.
(3) Press firmly down
90 degrees on to
the socket until the
arms lock.
SIMM Sockets
DIMM Sockets
(1) Align the
SIMMs to the
Socket. (Look
for the notch)
(2) Insert the SIMMs at a
45 degree angle.
(3) Snap the
SIMMs into
place as
shown in this
illustration.
int l
e
P5VPX97-AT.p65
6/16/98, 3:31 PM
9
