CONTINUED
CONTROL OPERATION VERIFICATION
❑
With the helicopter sitting on the ground, push the throttle control stick forward only enough to turn on the motors. The rotor blades
should begin to spin at a low rate of speed.
❑
After you're satisfied that the controls are lined up correctly and operating in the correct direction, unplug the LiPO battery and
turn off the transmitter.
❑
Looking from the front of the helicopter, push the cyclic control stick to
the right. The right side servo linkage should move up (A).
❑
Looking from the front of the helicopter, push the cyclic control stick to
the left. The right side servo linkage should move down (B).
IMPORTANT
If the servo linkage is not moving in the correct direction,
flip the Ch 2 servo reversing switch on the back of the transmitter.
❑
Looking from the front of the helicopter, pull the cyclic control stick back.
The left side servo linkage should move up (A).
❑
Looking from the front of the helicopter, push the cyclic control stick
forward. The left side servo linkage should move down (B).
IMPORTANT
If the servo linkage is not moving in the correct direction,
flip the Ch 3 servo reversing switch on the back of the transmitter.
❑
Looking from the back of the helicopter, push the yaw control stick to the
right. The tail of the helicopter should move right (A).
❑
Looking from the back of the helicopter, push the yaw control stick to the
left. The tail of the helicopter should move left (B).
IMPORTANT
If the tail of the helicopter doesn't move the correct direction,
flip the Ch 1 servo reversing switch on the back of the transmitter.
GETTING READY TO FLY YOUR M.A.S.H. ARMY RESCUE CHOPPER
CHARGING THE LIPO BATTERY
IMPORTANT
As a safety feature, the connectors can only be plugged
in one way.
❑
Plug the red battery connector on the LiPO battery into the red battery
connector on the charger. The charger LED will turn RED, indicating the
LiPO battery is charging.
❑
Allow the LiPO battery to charge. When the charging process is complete, the charger LED will turn GREEN. Once the charging
process is complete, remove the LiPO battery from the charger and reinstall it into the helicopter.
BEFORE chARGING ThE lIPO BATTERy, PlEASE REAd ANd UNdERSTANd ThE lIThIUM POlyMER BATTERy
WARNINGS ON PAGE 3.
❑
Plug the LiPO battery charger into an AC wall outlet. The charger LED will turn GREEN.
A
B
A
B
A
B