EemaX AP032208, Installation Instructions And Owner'S Manual

Page: 4 / 24

1) MOUNTING THE HEATER TO THE WALL
Your heater may or may not be installed in a NEMA 4/4X cabinet. Please follow the mounting instructions
as appropriate to your installation. Whenever possible, locate the heater as close to the point of hot water
use as possible. Time-to-temperature performance will improve the closer the heater is installed to the
point of use.
Make sure the brass fittings are at the bottom of the
heater and pointing “DOWN”. No other heater
orientation is permitted. Leave a service clearance of at
least 12” inches on the left and right sides of the heater.
SafeAdvantage: Install the heater with cabinet using the
supplied mounting feet following the instructions
provided with the cabinet. Be sure to use appropriately
rated fasteners to hold the cabinet/heater in place.
SpecAdvantage: Remove the cover by removing the
cover screws as indicated by the arrows (right) and
fasten the heater to the wall using the mounting holes
located at each corner of the back plate. Be sure to use
appropriately rated fasteners to hold the heater in place.
4
This heater must be installed in a location where
it is not subject to freezing temperatures.**
** Does not apply to SafeAdvantage with
Freeze Protection option.
SafeAdvantage
Spec Advantage
For all optional features
(GFCI, Freeze Protection, Electrical
Disconnect, Class 1/ Div 2, Siren/ Beacon)
Mounting Dimensions