8
PORTABLE MAGNETIC CORE DRILLING SYSTEM
ASSEMBLY
Coolant tank assembly required.
First attach clear tube to the bottom of the coolant tank. To
do this, first loosen the nut and slide nut onto the tube. Then slide tube onto the nipple. Then
tighten the nut. Slide tank hanger over the screw on the upper right hand side of slide and
tighten. Finally insert the other end of the tube into the quick-release connector in the
gearbox. Just directly push in to install.
(To remove, first firmly push the red collar of the
connector and pull the tube out.)
Cutting coolant fluid is always required when using annular
cutters. Open tank cover and fill. Check coolant fluid level often. Keep coolant tap closed
when not in use.
Chip guard must be used.
To attach the chip guard, use the supplied butterfly bolts to bolt to
the magnet. It is not necessary to remove guard to clean chips. Simply raise guard to its upper
position.
Safety chain must be used.
Loop chain around the work piece and feed through the
machine’s handle and clip in place.
MOUNTING ANNULAR CUTTERS
CAUTION: Never use a cutting tool that is larger than the maximum rated capacity of the
machine.
1. To insert an annular cutter, first insert the pilot pin into the
cutter. Then slide the cutter into the arbor, align the proper
flat with the locking screw(s) and tighten securely with the
supplied hex wrench.
CAUTION: Ensure that the locking screw is on a flat of the cutter and not just against the
rounded shank.
2. Ensure that the oil feed tap is on and coolant feeds properly by pushing the pilot pin. If it
feeds too quickly or slowly, adjust the tap accordingly. Keep the tap closed when not in use.
