Edwards PGC202, Instruction Manual

Page: 25 / 64

D0300041001EN - Installation
Page 15
Benchtop instrument
When intending to use the PGC202 as a benchtop instrument, then proceed as follows:

Push one of the two edge protection rubber pieces supplied with the product over the
top edge of the front panel (see Figure 4 item 1).

Place the PGC202 on its back (see Figure 4 item 2).

Push the second edge protection rubber piece supplied with the product onto the
bottom edge of the front panel.

Stick the two rubber feet supplied with the product onto the bottom of the housing.

Turn the PGC202 over again and move it to the desired place.
Figure 4 Preparing the instrument for utilisation as a benchtop unit
Connections
Rear side of the instrument
Figure 5 shows the rear panel of the PGC202. The way in which the individual connections
have been wired is described in the following sections.
WARNING:
When using the PGC202 as a benchtop instrument fit the two edge protection rubber
pieces onto the top and bottom edge of the front panel to avoid injury by sharp edges.
1. Top side
2. Bottom side