© Edwards Limited 2015. All rights reserved.
Page 11
Edwards and the Edwards logo are trademarks of Edwards Limited.
Technical data
D396-20-880 Issue H
2.6
Factory settings
2.7
Electrical connectors
Note:
Do not connect voltages greater than 45 V to the logic interface. If you do, the Controller will not comply
with the low voltage safety recommendations of IEC 1010.
Table 6 - Factory settings
Normal speed
80%
Internal Timer
8 min, enabled
Vent options
See
Analogue output
Speed output
Table 7 - Electrical connectors
Electrical supply connector socket type
CEE/IEC 320
Earth (ground) stud (on rear panel)
M4
Active gauge connector
Signals on the connector pins
and
Socket type
FCC68, 8-way
Manufacturer
Western Electric
Maximum power
3 W
Logic interface connector
15-way sub-miniature ‘D’ type socket
