© Edwards Limited 2010. All rights reserved.
Page 12
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
D397-50-880 Issue C
3.3
Electrical connections
Fit the electrical connections as specified in
.
3.3.1
TIC Profibus module rear connections
Figure 9 - TIC Profibus module rear connections
3.3.2
DX Profibus module rear connections
Figure 10 - DX Profibus module rear connections
3.4
Bus termination
Bus-termination is not supplied with the module, but must be used as for a normal Profibus DP system. Bus
termination must be used at both ends of the Profibus trunk and not anywhere else. If the module is placed at one
end of the trunk a connector containing the standard termination resistors should be used. The appropriate 5V and
0V signals are supplied on the standard pins for this purpose.
