METER LAYOUT
Explanation of the Results Screen
MENU OPTIONS
There are various OPERATING MODES and user-selectable options that will make your experience with the Glass-Chek ELITE more
convenient. All of these options are available in the MENU system. To access the MENU system, turn the meter on by pressing and releasing
the POWER BUTTON and wait for the WELCOME screen to complete its display. The WELCOME screen will show you the version of
software that is in your meter, as well as confirm the current OPERATING MODE that the meter is operating in. Be sure you have selected
the proper operating mode for your application. Choosing the wrong mode can result in incorrect measurement results, or no results at all.
Remember if you change the operating mode, it will stay in that mode for all future measurements, until you change it again by entering the
MENU system. Powering the meter OFF will NOT reset the operating mode.
WELCOME SCREEN
MEASUREMENT REMINDER SCREEN
After the WELCOME SCREEN, the meter will go to its measurement reminder screen, reminding you to
This is the preferred measurement location that should be used for ALL
MEASUREMENTS. Testing in this location will eliminate effects from glass that is flexing inward, resulting in a concave glass surface. The
most accurate measurements of a window will be obtained in this location when using the GC32000 meter.
After the measurement reminder screen appears, PRESS and HOLD one of the ARROW buttons for several seconds until the ENTERING
MENU screen appears. Release the ARROW button once that screen appears. You can enter the MENU system any time the meter is
powered on by pressing and holding one of the ARROW buttons. Please note that you may need to hold the ARROW button down for several
seconds before entering the MENU system.
place the GC3200 meter at the
bottom center of the window for ALL MEASUREMENTS!!
Page 2
software version #
current operating mode
The ARROW keys are used to:
-Scroll between measurement result screens
(forward and backwards)
-Press & Hold to enter the MENU system
-Move the cursor up and down in the MENU
-Toggle between options in the MENU
Results display: DATA
-Digital measurement results of the glass, air
space, laminate and overall IG thickness
-Also displays the type of Low E coating in the
window, and the surface location
Results display: DIAGRAM
-A profile drawing of the window is shown
at the bottom of the graphical display
-Each piece of glass is assigned a number
-Each glass surface is assigned a number
for better understanding of the
measurement results.
-Glass and Surface numbers match the
DATA results shown at the top of the
display
-Glass surface number will
on the
diagram if it is a Low E Coated surface
BLINK
The POWER button is used to:
-Turn the power ON (Momentary press)
-Turn the power OFF (Press & Hold)
-Take a measurement (Momentary press)
-Make a selection in the MENU
Glass thickness typically shown
in the left column
Graphic display shows the position
of the meter on the window.
Any identified Low E Surfaces will BLINK
on the graphic display to show the location.
GLASS #1 LAMINATE#1 GLASS #2 AIR SPACE #1 GLASS #3
Air Space and Laminate Inner Layer
thickness typically shown in the right column
