Assembly Instructions : Edsal 7000 Series Quick Assemble Storage Cabinets Page 4
Assembly Instructions : Edsal 7000 Series Quick Assemble Storage Cabinets Page 4
Assembly Instructions : Edsal 7000 Series Quick Assemble Storage Cabinets Page 4
Figure 5 - Door Assembly
Step 6 - Shelf Assembly
First select a level for the shelf by selecting a set of
square notches located inside the unit on the back left
and back right sides. A series of round holes are located
on the inside of the left and right hand side panels near
the hinges. Using a shelf clip, insert the upper notch into
a round hole opposite the selected square holes where
the shelf is to be located. Push and “snap” the lower
notch of the clip into place using the next lowest round
hole. Repeat the shelf clip installation on the opposite
corresponding side. To insert a shelf, angle the shelf so
that the back of the shelf will engage the square notches
on the back and lower onto the front shelf clips. Repeat
the process for all remaining shelves.
Figure 6 - Shelf Assembly
Step 7 - Final Assembly
To complete the unit, the locking handle needs to be in-
stalled on the right hand door. Follow carefully the as-
sembly instructions as written on the handle hardware
bag. Helpful hints on installation: The door rods will
slide into small plastic guides on the door. Install the
handle to the right hand door, then place the cam in posi-
tion. Slide the tip of the door rod into the lower plastic
guide and position the door rod onto the pin located on
the cam and hold it in place. Install the other door rod in
the upper plastic guide and position onto pin located on
the cam and Install the remaining hardware.
If wall an-
chor hardware was supplied with your model
, install
the hardware by drilling two holes into the backs of the
cabinet. Drill one on the left, and one on the right. Then
use the toggle bolts
THAT WERE SUPPLIED
to secure
the cabinet to a wall. If your unit
WAS NOT SUPPLIED
with anchor hardware, it is suggested to use a toggle bolt
similar to the picture on page 1. See your local hardware
dealer to purchase this type of hardware to properly se-
cure the unit to a wall.
Figure 7 - Final Assembly
Step 5 - Door Assembly
Now the doors are ready to be hung. With the hinge pins
pointed down, select the door with three (3) holes for the
handle cutout (see figure 5). This is the right hand door.
Take the right hand door and align the door’s hinge pins
with the companion hinges located on the right side
panel. Some of the hinge pins may have moved or come
out of alignment during shipping and handling. If so,
move the hinge pins back to the proper position so that
they align with the companion hinge holes. Slowly slide
the hinge pins into the holes and rotate the door slightly
from left to right while applying minimal downward pres-
sure until the pins seat properly to the companion hinges.
Repeat the same process for the opposite door.
