EDNord QMS 1060E, Getting Started

Page: 45 / 120

Installing
Options
2-19 Setting Up Your Printer
M
WARNING!
Turn the printer off and unplug the power cord before
checking for correct printer installation.
ACHTUNG!
Schalten Sie bitte den Drucker aus und ziehen Sie auch
den Netzstecker heraus, bevor Sie die korrekte Installation des
Druckers überprüfen.
Enabling/Disabling the Start-up Page
A start-up page automatically prints when you turn on your print sys-
tem. However, you can save time, paper, and toner by disabling the
start-up page.
If you need the information included on the start-up page after you
have disabled the page (for example, to provide to the QMS Cus-
tomer Technical Assurance staff when you need technical support).
The two easiest ways to disable (and enable) the start-up page are
1 Use the PS Executive Series Utilities.
See the PS Executive Series Utilities on-line help for complete
information.
2 Use the printer control panel (Administration/Startup
Options/Do Start Page menu).
See “Enabling/Disabling the Start-up Page” in chapter 4, “Printer
Configuration,” of the
Reference guide for complete information.
Installing Options
If you purchased any printer options, such as extra memory (SIMMs),
emulations, a SCSI-IDE board, a network interface card, or an inter-
nal hard disk drive, install them now. If installation instructions are
included with the option, follow them. If not, installation instructions
are included in chapter 6, “Printer Options,” of the
Reference guide.
EDNord - Istedgade 37A - 9000 Aalborg - telfon 96333500