REF.
07678
INSTRUCCIONES IMPORTANTES DE SEGURIDAD
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
PARTS OF THE MIXER
1) Measuring cup
2) Glass cover
3) Glass cup
4) Seal ring
5) Cutting blades
6) Cup base
7) Motor base
8) Rotary switch
BEFORE THE FIRST USE
- All parts of the blender must be thoroughly cleaned before use.
- Pull out the required length of cable from the ordered cable at the base of the
blender and connect the device to the mains.
Assemble the jar:
- Place the rubber sealing ring (4) on the inner edge of the knife unit (5).
- Place the knife unit with sealing ring on the base of the cup (6).
- Mount the carafe (3) on the cup base unit and tune the cup base unit, and
turn clockwise until the carafe clicks into place.
- Mount the Measuring Vessel (1) on the lid of the jug (2).
- Secure the lid on Jar and press down.
Insert the jar:
- Make sure the blender is switched off (Change in setting '0').
- Place the bowl assembly on the motor base unit (7) which is securely
attached.
HOW TO USE
- Put the food product you want to process in the container.
- Put the lid on the container and close it securely. Place the measuring cap
into the hole in the cap and turn it clockwise to lock it.
- Mount the glass cup to the cup base unit and tune the cup base unit, and
tune the cup base unit to the steering unit clockwise.
START THE MOTOR BASE
After using the blender, always move the switch to setting '0' and disconnect
the plug from the mains.
To remove the glass beaker, simply lift it from the motor base. It is not necessary
to turn it to remove it.
HELPFUL TIPS
- For best results when mashing (cooked solid ingredients), place small portions
in the glass jar, one by one, instead of pouring a large amount in one go.
- If you are processing carrots, first cut them into small pieces (1 - 1.5cm).
The maximum recommended amount of carrots should not exceed 720g. Then
add water, note that the total weight should be less than 1,800g.
- Whenever you want to process solid ingredients, first cut them into small
pieces (1-1.5 cm).
- When mixing the solid ingredients, start with a small amount of liquid first.
Gradually add more and more liquid through the opening in the lid.
-
Always place your hand on the blender when you are using the device.
- To remove solid or very thick liquid ingredients, we recommend that you use
the blender in boost mode to prevent the blades from jamming.
SPECIFICATION
Voltage: AC 220V-240V - 50 / 60Hz
Power: 550W
Short-term operation: max. 2 minutes for the blender
ENGINE BASE
Never immerse the motor base in water. Clean only with a damp cloth.
CLEANING
To clean the glass beaker:
- Empty the glass cup and fill it with water and a little liquid soap.
- Place the glass container on the base of the motor and turn the switch several
times in the 'M' setting.
- Empty the glass beaker and rinse until clean.
To clean the motor base:
- Wipe it with a damp cloth of water (no detergents) and dry it well.
1
2
3
6
4
5
7
8
