REF. 08709
EN
INSTRUCTION MANUAL
OPERATING INSTRUCTIONS
Assembling abrasive discs & grinding stones to accessory shaft 1 (Pic. 3)
1. Mount the selected disc onto the accessory shaft as illustrated. Ensure the two washers are correctly placed.
2. Do not over-tighten the screw.
Assembling abrasive bands to accessory shaft 2 (Pic. 4)
1. Slide the abrasive band over the rubber section of the shaft.
2. Ensure the abrasive band fits straight and evenly over the rubber portion of the shaft.
Assembling polishing felts to accessory shaft 3 (Pic. 5)
1. Screw the polishing felt onto the tip of the accessory shaft.
2. The tip of the shaft should not protrude through the felt. Do not cover-screw the felt.
Assembling the flexible shaft assembly (Pic. 6)
1. Switch off the tool and disconnect from the mains power supply.
2. Unscrew and remove the securing ring.
3. Push the spindle lock and hold. Rotate the spring chuck so that it locks into place.
4. While the spindle lock is engaged, use the spanner (supplied) to loosen the spring chuck. (Do not remove the spring chuck).
5. Fit the inner cable of the flexible shaft firmly through the spring chuck and into the collet, ensuring that it is a firm fit.
6. Push the spindle lock and hold. Rotate the spring chuck so that it locks into place.
7. While the spindle lock is engaged, use the spanner (supplied) to tighten the spring chuck.
8. Slide the outer cable of the flexible shaft over the spring chuck and tighten the securing ring onto the flexible shaft.
Fitting the accessories to the flexible shaft (Pic. 7)
1. Switch off the tool and disconnect from the mains power supply.
2. Pull back the protective sleeve and loosen the spring chuck.
3. Insert the required accessory and tighten the spring chuck.
Fitting the accessories to the tool (Pic. 2)
1. Switch off the tool and disconnect from the mains power
supply before fitting accessories.
2. Push the spindle lock and hold. Rotate the spring chuck so
that it locks into place.
3. While the spindle lock is engaged, use the spanner
(supplied) to loosen the spring chuck. (Do not remove the
spring chuck).
4. Fit the required accessory firmly through the spring chuck
and into the collet. Ensure it is a firm fit.
Note: There are five collets with this tool. Always ensure that
the axle diameter of the accessory being used is the same as
the collet diameter.
5. Push the spindle lock and hold.
6. While the spindle lock is engaged use the spanner
(supplied) to tighten the spring chuck.
ROTARY TOOL KIT 170W
