Congratulations on your choice of EDISION argus piccollo 3in1 plus CI receiver.
Please note that all the information included in this leaflet are valid at the date of printing the document.
Currently updated information and comprehensive manual are available at: www.edision.gr
Open package
Connection
IR remote control with 2x AAA batteries
Information
Service
information
piccollo 3in1 plus CI
1
2
piccollo 3in1
1
HDMI in
2
HD
m
i
kabel
HDMI
kabel
Antenna cable
Cable satellite antenna
Argus piccollo 3in1 plus CI receiver
Note:
The front cover may be covered by a transparent plastic film from the factory, that can be easily peeled off.
The package may include accessories that are not mentioned in the respective section.
Front panel
1 POWER button: Activates/Deactivates the device.
2 Exit the window with the menu / dialog.
3 MENU: Εμφάνιση ή απόκρυψη κεντρικού μενού.
4 OK button: displays the Program list and/or cursor movement in the menus.
5 Up/Down buttons: for moving in the program lists and/or cursor movement in the menus.
6 Left/Right buttons: for volume adjustment and/or cursor movement in the menus.
7
/ USB port: for connecting external USB storage devices.
8 The green LED lights up when the receiver is turned on. The red LED lights up when the receiver is in Standby mode.
9 Display: Display including the time and location of the program.
10 Infrared sensor for the reception of remote control commands.
11 Embedded card reader.
12 Port for Conditional Access Module (CAM).
Rear side
13 ANT IN: Input for connecting to terrestrial or cable signal from the antenna.
14 LNB IN: For connecting the coaxial cable from the LNB, using the proper plug.
15 S/PDIF: Audio interface for amplifier/audio console.
16
/ USB: Port for connecting USB memory devices
17 CVBS: Video output.
18 0/12V 50mA: Circuit voltage for connecting external devices..
19 L / R: Output amplifiers Audio.
20 HDMI:For connection to a TV set, using HDMI cable. For HD TV signals.
21 RS 232: For connecting to a PC, using RS-232 cable, for receiver software update.
22 ETHERNET (RJ45): For connection with LAN/INTERNET, for home use.
23 POWER: ON/OFF of the receiver power supply.
Note: For trouble-free TV signal reception,
the installation and calibration should be carried
out by a qualified professional.
• Connect the receiver using HDMI cable
via the HDMI output port to your TV’s HDMI input port
• Now connect the receiver to the satellite
antenna cable via the LNB IN input
• Insert the batteries into the remote control.
Notes on the remote control can be found on
the back of these instructions
• Some functions of the receiver increases comfort during use - but only work in combination with the Internet connection. If you wish to use these functions,
connect the device via the Ethernet interface with LAN cable - (RJ45) at the entrance of your internet.
• Connect the receiver to the mains socket.
• Activate the receiver by pressing the ON/OFF switch in the back, to the «ON» position.
The receiver goes into «BOOT» mode and after a few moments it is ready for use.
1
3 4
5
6
7
2
9
8
For complete
after sales
service, please
contact
your EDISION
specialist dealer.
power outlet
HDMI:
Line OUT
HDMI cable
TV connection panel
Use an HDMI input!
23
21
22
20
16
14
15
19
17
18
13
11
12
10
ANT IN: coaxial-wire input
from terrestrial / cable signal
LNB IN:Connection for the
coaxial cable from the LNB
