INTERFACE BOARDS
stop working correctly!
Setting
Left picture - settings on
the first STR device
(exam. IP: 10.9.81.
80
)
Right picture - settings on
the second STR device
(exam. IP: 10.9.81.
81
)
Endpoint Configuration / Remote Host
Second STR device IP
(IP: 10.9.81.
81
)
First STR device IP
(IP: 10.9.81.
80
)
Set IP on both STR devices according to your needs.
NOTE! Always press "OK" when settings is changed. Press „Apply Settings“ to save settings into
device! Wait for device to reset.
NOTE! If you want to check the setting on the device, close your web browser otherwise (old)
settings will be displayed from computer's cache rather than from STR device itself.
4.3 IO BOARDS
On boards are:
microcontroller
4 DIs
4 DOs or 3DOs + 1 „device ready“ DO (depends on ordering)
8 switches
Microcontroller is the heart of device. It scans DIs, controls DOs and communicates via protocol.
Digital inputs are scaned every 0,1 ms. Debounce filter is 20. That means that digital input will
be recognized as active, if in all 20 cycles status of digital input will be high.
Digital outputs 1-3 are controlled by communication. After positive command request, requested
digital output will be activated for 500 ms. After that time, digital output will be automaticly
returned to its initial state.
Digital inputs and digital outputs statuses are indicated by LEDs on front side of device.
User can choose from following list:
IOL – 4 Digital Input (24 V DC), 4 Digital Output board
IO4 – 4 Digital Input (48 V DC), 4 Digital Output board
IO1 – 4 Digital Input (110 V DC), 4 Digital Output board
IO2 – 4 Digital Input (220 V DC), 4 Digital Output board
IO4R – 4 Digital Input (48 V DC), 3 Digital O 1 „device ready“ DO board
IO1R – 4 Digital Input (110 V DC), 3 Digital O 1 „device ready“ DO board
IO2R – 4 Digital Input (220 V DC), 3 Digital O 1 „device ready“ DO board
Company:
Device:
Document:
Code:
Date:
Page:
User manual STRMUED1
21
