Edirol RG-100, Owner'S Manual

Page: 111 / 128

111
Using the remote control terminals
You can remotely control external devices from the RG-100 by
connecting them to the screw-type remote control terminals on the
rear panel of this unit.
This section introduces how to make connections with external
devices, and how to set up this unit.
For sample connections with remote control terminals, refer to
“Using the remote IN/OUT control terminals”
(p. 23).
For information regarding the specifications of the remote
control terminals, refer to
“Remote control terminal
specifications” (p. 111).
Note on using the remote control terminals
When making connections to the terminals, be sure not to lose
the screws. Also, keep the screws away from children’s reach. If
your child has swallowed a screw by accident, call a doctor
immediately.
About the Busy Out signals/
connection with devices
Busy Out signals are signals that are continuously sent from the
BUSY terminals during movie playback in Play Mode (p. 94),
You can use these signals to start up external devices, such as
amplifiers.
The BUSY signals should meet these specifications: at the no-voltage
contact point, the contact point capacity is DC 30 V, 3A maximum.
When transmitting, the two BUSY terminals on the rear panel of the
unit make the contact point.
About the Control Out signals/
connection with devices
The Control Out signals are RELAY ON/OFF signals that are sent
according to the settings made using the Scheduler function.
You can use these signals to control external connected devices as
have been scheduled.
The two CONT OUT terminals on the rear panel of the unit make the
contact point to transmit.
fig.seigyo02.eps
CONTROL IN
• Start up method: No-voltage make contact points, or open
collector transmission (pulse bandwidth over 20 ms)
• Input method: Photocoupler method
CONTROL OUT
• Start up method: No-voltage make contact points
• Contact point capacity: DC 30 V, 3 A
• Terminals used for transmission: BUSY out
When making connections to the terminals, be sure not to lose
the screws. Also, keep the screws away from children’s reach. If
your child has swallowed a screw by accident, call a doctor
immediately.
Remotely controlling
external devices with the
RG-100
Starting up other devices (Busy
Out)
Remotely controlling external
connected devices (Control Out)
Remote control terminal
specifications
Terminal Terminal
name
Signal name
CONTROL IN 1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
MUTE MUTE
TIME ADJ TIME ADJ
COM COM
CONTROL OUT BUSY BUSY
CONT OUT RELAY ON/OFF
000RG-100.book 111 ページ ２００４年８月６日 金曜日 午後５時３７分