58
Using the PCR-A30 as a MIDI controller
Advanced mode 1–3
Advanced mode 1 of AFTERTOUCH ASSIGN lets you specify the upper and lower limits of the
aftertouch value in addition to the items of Basic mode. Advanced modes 2 and 3 let you specify
an aftertouch message for an individual note (Polyphonic Key Pressure) instead of specifying the
channel.
1.
Press the
[EDIT]
button.
2.
Slightly move the controller to which you want to assign an Aftertouch message. In the case of a
button, press that button.
The display will indicate the number of the selected controller.
3.
Verify that the display indicates the correct controller, and press the
[ENTER]
button.
fig.at1
4.
Press the [AFTERTOUCH] key and then press a key
[1]
–
[3]
.
The display will indicate the selected mode.
5.
Press the
[ENTER]
button.
6.
Input the channel.
7.
Press the
[ENTER]
button.
8.
If you are using Advanced modes 2 or 3, input the note number.
9.
If you are using Advanced modes 2 or 3, Press the
[ENTER]
button.
10.
If you are using Advanced modes 1 or 3, specify the upper limit and lower limit of the value as
“Specifying the range of values (upper and lower limits)”
, and specify the output
port.
11.
If you are making an assignment for a button, specify the button mode.
(
➔
Specifying the range of values (upper and lower limits)
If in Edit mode you selected an Assign type (p. 53) that lets you specify the range of values, you
will need to specify the upper limit and lower limit of the value.
fig.max
1.
The following display will appear.
2.
Use the
[DEC][INC]
buttons or the
[0]
–
[F]
keys to specify the upper limit.
fig.min
3.
Press the
[ENTER]
button.
The following display will appear.
4.
Use the
[DEC][INC]
buttons or the
[0]
–
[F]
keys to specify the lower limit.
5.
Press the
[ENTER]
button.
* Normally, when using Decimal input mode, the value you are specifying appears in the display as a three
digit number. This means that there is no indication of which parameter you are currently entering, so
you may lose track of what you are doing. If this occurs, you can temporarily switch to Hex input mode
to check the parameter that you are now inputting. Then switch back to Decimal input mode and
continue. (
➔
*1 Reference
*1 Reference
*1 The -- area displays the currently set value. If it has not been set, the default setting will be displayed. Even if you change the type or mode
of the MIDI message that is assigned, the default setting will be displayed. This will be lit if the value is the same as the currently set value,
or will blink if the value is different.
PCR-A30_e2.book 58 ページ 2003年10月22日 水曜日 午後3時19分