7
Figure 2
4. Connect the cables power supply, loop pad and microphone, see page 5. If the wall
holder is being used, run the cables from the loop driver’s power supply, loop pad and
microphone through the wall holder from underneath. Place the driver in such a way
that the connector side is facing down and you can read the text on the front of the
driver in the right direction. Connect all three cables, see page 5. Finally, lower the
driver into the wall holder and connect the power supply to mains.
5. When all connections are completed correctly the LED-indicator for mains power on the
right hand side of the front of the driver shall light up. The system is now ready to be
used.
6. The loop current is adjusted by turning the volume control at the front of the driver.
Verify the loop level/volume with a Univox® Listener. Bass and treble controls shall only
be adjusted in exceptional cases.
Microphone
Place the loop pad in the angle
between the front and the upper part
under the reception desk.
Placing the loop pad in the highest
position possible ensures a stronger
magnetic field and thus gives better
speech perception for hearing aid users
