Edimax WP-S1100, User Manual

Page: 86 / 88

86
4-2 Troubleshooting
Don’t panic if projector server is not function properly! In most cases, you can
solve the problem by yourself and you don’t have to send the projector server
back to dealer of purchase to ask of help. Please refer to this troubleshooting
table to find out possible solution.
Scenario Solution
Can’t connect to
projector server
1. Check the LED lights located at the front of projector
server. If ‘Power’ LED does not light, do the following
check:
z
Check the connection of Power adapter, and if the
electrical outlet you used with Power adapter is
functioning properly.
z
Press ‘Power’ button to see if ‘Power’ LED lights
now.
2. If ‘Ready’ LED does not light after you switch the
projector server on after more than 2 minutes, ask the
dealer of purchase for help.
3. Check the network connection.
4. Make sure you connected to correct IP address.
5. If you’re using wireless network, make sure you
connected to correct SSID.
6. If you’re using wireless network, check the WEP /
WPA password.
Remote controller
does not work
1. Replace the battery of remote controller with a new
one (CR-2032 lithium battery).
2. Please point the IR transmitter (located at the top of
remote controller) to the front panel of projector server.
3. Make sure the IR receiver of projector server (labeled