Edimax AR-7286WnA, User Manual

Page: 50 / 92

50
The following table describes the parameters of this page:
Field Description
IP Common Options
Encapsulation
You can choose 1483 Bridged IP LLC , 1483 Bridged IP
VC-Mux , 1483 Routed IP LLC(IPoA) or 1483 Routed
IP VC-Mux .
IP Unnumbered You can choose Activated or Deactivated .
Default Route
You can enable or disable the default route. If
enabled, the current PVC will be the default gateway
to the Internet from this device.
TCP MTU Option
You can set a TCP MTU value. The range is from 100
to 1500. The default is
1492 .
IPv4 Address
NAT
Select whether to enable Network Address
Translation (NAT) function. If you do not enable NAT,
you must add a route on the uplink equipment,
otherwise Internet access will fail. Normally NAT is
enabled.
Dynamic Route
Select this option to specify the Routing Information
protocol (RIP) version. You can select
RIP1 , RIP2-B or
RIP2-M .
Direction
You can select None , Both , IN Only or OUT Only to
specify the RIP direction. None is for disabling the
RIP function. Both means the ADSL Router will
periodically send routing information and accept
routing information then incorporate into routing
table.
IN only means the ADLS router will only
accept but will not send RIP packets. OUT only
means the ADLS router will only send but not accept
RIP packets.
Multicast
IGMP (Internet Group Multicast Protocol) is a
session-layer protocol used to establish membership
in a multicast group. The ADSL Router supports both