40
Bridge Interface
This router has built-in ADSL modem and is able to
connect to ISP directly. Alternatively, if you want to use
the dial up software to manually connect to the ISP, you
have to activate the
”Bridge Interface”.
Connection
Always On
– The connection will be kept always on. If
the connection is interrupted, the router will re-connect
automatically.
Connect On-Demand
– Only connect when you want to
surf the Internet.
“Close if idle for xx minutes” is set to
stop the connection when the network traffic is not
sending or receiving after an idle time.
Connect Manually
– After you have selected this option,
please go to Status page. You will see the
“Connect”
button, click it and the router will connect to the ISP. If
you want to stop the connection, please click
“Disconnect” button.
TCP MSS Option
The “TCP MSS Option” enables the configuration of the
maximum segment size (MSS) for transient packets that
traverse a router, specifically TCP segments in the SYN
bit set, when PPPoE is being used in the network. Please
specify the MSS range from 100 to 1452 bytes or 0 byte
as the default value.
Default Route
When
“Default Router” is enabled, all the packets for
destinations not known by the router's routing table are
sent to the default route. By default, it is enabled.
Get IP Address
Choose Static or Dynamic IP Address. If Static IP is
selected, please set the IP Address, Subnet Mask and
Gateway obtained from your ISP.
