23
ENGLISH
REMOTE CONTROL
This controls all the functions. It is necessary to point it
directly at the boiler-fireplace.
For further information contact our customer service
centre.
Indicates data transmission between the remote control
and the control board.
low batteries; replace them and put them in their appropria-
te containers.
blocked keypad; avoid turning on the remote control for no
reason (press “A” and “M” simultaneously for a few secon-
ds to block/unblock the keypad)
Indicates that ignition / shutdown is being via the “EASY
TIMER” program
Indicates the room temperature detected by the remote
control (it indicates the values of the set parameters during its
technical set-up).
On icon: boiler-fireplace in start-up/operating phase
Indicates that the boiler-fireplace is operating in automatic
mode
pellet/water boiler-fireplace remote control setting indicator
USING THE “EASY TIMER” PROGRAM
The new remote control allows you to manage a new ti-
mer program that is very intuitive and easy to use:
-
If the boiler-fireplace is on:
a delayed shutdown
can be set from the remote control - from one to twelve
hours. The remaining time for the scheduled shutdown is
shown on the display of the synoptic panel.
-
If the boiler-fireplace is off
: a delayed ignition
can be set from the remote control - from one to twelve
hours. The remaining time for the scheduled ignition is
shown on the display of the synoptic panel.
-
Setting:
proceed as follows to set the timer:
a) Press the “A” button and the icon will light up on the
display, thereby confirming the “Easy timer” program has
been accessed.
b) Set the hours by pressing the +/- buttons, for example:
c)Point the remote control towards the synoptic panel re-
ceiver
d) Confirm the setting by pressing the “A” button for a few
seconds; the icon will go off and the remaining time
will appear on the synoptic panel after which the “Easy
timer” setting will intervene.
e) Repeat points a), b), c), d) to cancel the setting, and
set the hours to “00H”
BLOCKED KEYPAD
The remote control buttons can be blocked so as to
prevent it from going on accidentally.
Press the A and M buttons simultaneously and the key
symbol will light up confirming that the keys have been
blocked.
Press the A and M buttons simultaneously once again to
unblock the keypad.
LOW BATTERY INDICATOR
When the battery icon lights up it indicates that the bat-
teries inside the remote control are almost flat.
Replace them with three new batteries of the same mo-
del (size AAA 1.5V).
- Do not use new batteries with used ones.
- Do not mix brands and different types as every type
and brand has a different capacity.
- Do not mix traditional batteries with rechargeable ones;
- Do not try recharging alkaline and zinc-carbon bat-
teries as this can cause them to break and/or a liquid
leakage.
Key to buttons and display:
: ignition / shutdown button
+/-
: to increase/decrease the various regulations
A
: button to switch to the “EASY TIMER ” program
M
: key for viewing/setting the set temperature (Set
70°C)
INSTRUCTIONS FOR USE
USER
