EdgeMarc 4604 Enterprise Session Border Controller Installation Guide
4
Name
Description
A
Power
Off
Power switch is off (or no power from the AC outlet).
Green
Power is supplied to the unit.
B
Status
Off
The unit could not boot up because of self-test failure.
Green
Self-test passed.
C
Erase Button
If pressed twice in quick succession, only the CLI password will be
changed back to its original password.
If pressed three times in quick succession, the EdgeMarc will revert back
to the factory default settings. This will reset all passwords and erase all
prior configurations. The default LAN address will be set to 192.168.1.1.
Caution
Using the Erase button as outlined above means any configuration made
to the EdgeMarc 4603 will be lost. Erasing the configuration means that IP
phones installed behind the EdgeMarc 4603 will not work and Internet
connectivity or network access for PCs will be down until the system is
reconfigured.
D
10/100
Ethernet LAN
Ports
Four (4) Local Area Network (LAN) ports to connect the IP phones or an
Ethernet switch. Unit can also be configured through any of these ports
using the web interface.
E
10/100
Ethernet WAN
Port
Can be used as an alternative or in addition to the T1/E1 WAN ports. This
port is typically used when connecting the EdgeMarc 4603 to an existing
WAN router, cable or xDSL modem.
F
USB Ports
2 (Version 2.0) x USB ports can be used for EVDO WAN connections and
maintenance functions.
G
Management
Console Port
This port is used to establish a local console session with the EdgeMarc
4603 using a VT100 terminal or emulation program. The cable required is
a Male to Female straight-through DB-9 cable. The serial port uses a
baud rate of 9600, 8 data bits, 1 stop bit and no parity.
This port is used for debug or local diagnostic purposes only. Primary
configuration of the EdgeMarc 4603 is performed from a web browser as
covered in
Edgewater Networks
VoIP Operating System (VOS) for
EdgeMarc User Manual.
H
V.90 Dial-In
Console
Used to establish a local console session with the EdgeMarc 4603 using a
PTSN connection. The connection is established by calling into the
EdgeMarc 4603 from a dial-up modem. The web-interface is not available
using this option.
Note: The EdgeMarc 4603 requires a V.90 RJ-11 cable. For further
instruction on connecting the device, consult the
Edgewater Networks
VoIP Operating System (VOS) for EdgeMarc User Manual.
I
T1/E1 WAN
4 T1/E1 ports Off
T1 cable is not connected to the device.
