Edge10 edgedupe SD707, User Manual

Page: 9 / 17

8
2.2 SET UP Functions
2.2.1 Copy Area—Quick Copy Mode (Setup 6.2)
ON—Only Data Area. When this function is ON, the system will automatically
analyse the source flash card’s file format. If the file format is FAT12/16/32 file
system which the duplicator recognises then the system will only copy the
content data instead of copying the whole flash card including the empty space.
For example a 2GB flash card which is FAT32 file format and has only 50 MB of
data inside, the system will only copy that specific 50MB of data. Which will only
take a few seconds to copy the source.
OFF—Whole Media (RAW card copy). If the Copy Area function was set to
OFF the system will copy the whole flash card, including the empty space and
format. This function is used when you have a flash source which has an
unknown file format and you don’t want the system to be confused by such a
format.
2.2.2 Asynchronous Hold time (Setup 6.4)
This is to set the time to exit asynchronous copying when you’ve temporarily finished
copying and you’ve pulled out all the devices but you haven’t exited the copying job.
This is to prevent you from mistakenly overwriting a source device when you’d like to
start a new source copy but you forgot to stop the previous asynchronous copying job.
The default setting is 30 seconds. When the system detects that all the flash cards
have been pulled and no new cards have been plugged in after 30 seconds the LCD
will display:
Press OK to exit this Asynchronous or press ESC to keep this status.
Wait too long
Exit
？