1 Route the Switch harness from the PCM to the desired mounting location of the
Switch.
2 With a 3/8” drill bit, drill a hole to mount the Switch in.
3 Align and adhere the level indicator label around the hole as desired.
4 Mount the Switch in the hole and connect the Switch harness to the Switch.
CAUTION: The Switch has a nut and two washers. The smooth washer must
remain on the bottom with the tab located in hole between 6 and 7. If it falls
out, turn the Switch fully counter clockwise and place the washer back with
the pin in the hole between 6 and 7. Make sure the Switch moves exactly 5
clicks clockwise. If not, turn the switch back fully counterclockwise, move the
pin, and try again.
12
SWITCH INSTALLATION
Required Tools
- 3/8” Drill bit
- Allen wrench
Summary of Contents for REVOLVER
Page 1: ...User Manual ...
