Main
out
Input
1 2 3 4
Tape
Monitor
On/Off Switch
AC Input Module
Fuse Holder
Tape Monitor
Located on the back panel. The 2 RCA jacks
on the far right of the set of jacks.
This jack is used to send a nonvaring signal to the tape deck or
CD burner, etc. Whatever input is selected on the front panel
will also go to the tape monitor jacks. This signal is steady state
and will not vary with volume control changes on the preamp.
R
L
page 6
Speaker Connections
G 3 model only
Located center of the back panel
Resetable
Speaker Fuse
G1 or G2
G3
Speaker Terminals
AC Input
Module
R
L
Main
out
Input
1 2 3 4
Tape
Monitor
Located in the right side of the back plate.
Switch OFF:
Rocker(with 0) is down. Unit is in the stand-by
mode, so no functions are available.
Switch ON:
Rocker (with - ) is down. Dials on the front of the
unit will light up blue when mode selector in AC or DC.
WARNING!
Always make sure the power switches of your preamplifier,
amplifier, and source units are OFF and power indicator light is
OFF before making or disconnecting ANY connections. Never
plug in this unit and any components until all connections are
completed.
Step 1
RCA from Source:
Connect your RCA interconnect cables from your
source (CD, DVD, DSS, AUX1 and AUX2) to the
corresponding left / right RCA input on your
preamplifier.
Step 2
AMP-RCA Interconnects:
Connect your RCA interconnect cables from your
preamplifier outputs to the corresponding
left/right RCA inputs on your amplifier.
Step 3
Record Interconnects:
Connect your record cables from the corre
sponding left/right outputs on your preamplifier to
the recording device. Never plug record outputs
directly into your amplifier.
Step 4
AC Power Cord:
Connect your AC cord to the back of the
preamplifier and plug it into a grounded,
surge-protected outlet.
On / Off Switch
Setup & Cable Connections
page 5
