8
MAINTENANCE AND CARE
3. Remove Brush Roller Assembly
• Lift Roller Assembly while guiding end cap past belt.
4. Remove Belt
• Guide belt past drive gear on motor.
5. Replace Belt
• Only use Edge Belt # 90-01.
• Guide new belt over gear on motor.
• Guide new belt over end cap of brush roll.
6. Replace Brush Roller
• Place brush roller assembly with belt over gear into base assembly. Note:
Narrow side of end cap faces down.
7. Reverse steps above to reassemble the powerhead
• Make certain all wires are in their original positions.
• Take care when placing the neck assembly into its original position. The
yellow wires from the neck must move freely through the ‘gate’ under the
neck axis pivot. Be certain wires do not become “pinched.”
Changing the Brush Roller
Depending on usage and flooring type the brush will become worn and will need
to be replaced.
**Only replace the complete brush
assembly (brush, axles, bearings, end
caps, part #9193).
To remove roller brush
1. Remove Cover
• Depress Neck Release Pedal and
remove (8) #10 Torx screws, set aside
for reassembly. Note: longer screws
are in front of the brush roller.
Remove 8 Torx Screws
