27:
Replace the DVR-RGB-60 cover.
28:
Replace the power supply cover and secure it by tightening
the six Phillips screws.
7
Q
19
18
18:
Connect the white power supply wire marked "+" to
DVR-RGB-60 "Vdc+" red terminal.
19:
Connect the black power supply wire marked "-" to
DVR-RGB-60 "Vdc-" blue terminal.
20:
Use the "Low Voltage Wire Size Chart" on page 1 to
determine proper wire size connecting to the DVR-RGB-60
terminals.
21:
Run the proper size green, red, blue, and black wires from
the RGB LED soft strip to the power supply case.
22:
Run the proper size green, red, blue, and black wires from
the RGB LED soft strip to the power supply case.
23:
Connect the black wire into DVR-RBG-60 "LED "
white terminal. Connect the other end to RGB soft strip
black wire(s).
24:
Connect the red wire into DVR-RBG-60 "Group 1-" red
terminal. Connect the other end to RGB soft strip red
wire(s).
25:
Connect the green wire into DVR-RBG-60 "Group 2-" green
terminal. Connect the other end to RGB soft strip green
wire(s).
26:
Connect the blue wire into DVR-RGB-60 "Group 3-" blue
terminal. Connect the other end to RGB soft strip red
wire(s).
NOTE:
Use only 12 volt LED RGB soft strip with this power
supply.
R
LED SOFT STRIP
23
24
21
NOTE:
The DVR-RGB-60 terminals adapt maximum 18 AWG
size. To avoid voltage drop, use 6" of 18 AWG size in RGB
terminals connected inline to proper size gauge wire attached
to the RGB LED wires with wire nuts. See the "Low Voltage
Wire Size Chart" on page 1.
25
26
S
COVER
0-10V
Dimming
LED +
LED -
L N G
PHILLIPS SCREW
28
"N" White
"L" Black
" " GREEN
White +
Black -
M
CONDUIT
NOTE:
This power supply is for multiple runs.
Do not exceed
the maximum wattage of the power supply.
