Edge-Core WA6202A, User Manual

Page: 245 / 332

Example
Wireless Interface Commands
7
Enterprise AP#show interface ethernet
Ethernet Interface Information
========================================
IP Address
: 192.168.1.1
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.1.253
Primary DNS : 192.168.1.55
Secondary DNS : 10.1.0.55
Speed-duplex : 100Base-TX Half Duplex
Admin status : Up
Operational status : Up
========================================
Enterprise AP#
Wireless Interface Commands
The commands described in this section configure connection parameters for the
wireless interfaces.
Table 7-17. Wireless Interface Commands
Command Function Mode Page
interface wireless Enters wireless interface configuration mode GC 7-95
vap Provides access to the VAP interface configuration
mode
IC-W 7-95
speed
Configures the maximum data rate at which the
access point transmits unicast packets
IC-W 7-96
turbo Configures turbo mode to use a faster data rate IC-W (a) 7-96
multicast-data-rate
Configures the maximum rate for transmitting
multicast packets on the wireless interface
IC-W 7-97
channel Configures the radio channel IC-W 7-98
transmit-power
Adjusts the power of the radio signals transmitted
from the access point
IC-W 7-98
radio-mode Forces the operating mode of the 802.11g radio IC-W (b/g) 7-99
preamble Sets the length of the 802.11g signal preamble IC-W (b/g) 7-100
antenna control
Selects the antenna control method to use for the
radio
IC-W 7-101
antenna id Selects the antenna ID to use for the radio IC-W 7-101
antenna location Selects the location of the antenna IC-W 7-102
7-93