Edge-Core RPS900W, Installation Manual

Page: 22 / 28

Chapter 2
| Installing the RPS
Connecting the RPS to a Switch and AC Power Source
– 22 –
2.
Connect the DB-25 male end to the DC output connector on the RPS.
3.
Connect one end of the AC cord to the AC socket on the RPS, and the other end to
a grounded power outlet.
Figure 10: AC Power Cord and Power Socket
Caution: The RPS requires power from an external AC power supply that can
meet the required specification described in Table 2 . A standard AC power
socket is located on the rear panel of the RPS. The power socket is for the AC
power cord.
Note: If your country’s AC power outlet standards do not match the power
plug of the included AC power cord, you will need to change the AC power
cord. You must use a cord set that has been approved for the socket type in
your country.
AC Power Cord AC Power Socket
1
2
1 2